Mechanical Engineer II (Engineer II)

Job Title: Mechanical Engineer II - FPC (Fans, Pumps and Compressors) Location: Irvine, CA Duration: 6 Months Job Summary: The Mechanical Engineer will carry out engineering assignments concerned with the planning, design and testing of mechanical equipment, systems, and processes. Works cooperatively with other departments. Essential Duties & Responsibilities: Designs mechanical equipment, systems, and processes. Performs calculations and analyses to ensure suitability of design. Solves problems related to the assembly, repair, and test of environmental control systems. Under general supervision, performs assignments which involve responsibility for a secondary project or a part of a major project. Defense or aerospace industry experience desired. Experience in the development of thermal systems is a strong plus. Experience with electrical circuits and control theory a plus. May give directions and/or guidance to junior level engineers, designers, and drafters. Works with colleagues in the department and in other departments. Writes reports as required. Presents designs to peers, other engineers, and customers. Works under supervision, performs assignments of medium complexity and may assist senior engineers with more complex assignments. Qualifications: " Bachelor s degree in mechanical engineering or related field. " Master s degree in mechanical engineering or related field or an MBA is considered a plus. " Three to five years of experience with design and fabrication of mechanical and electro-mechanical systems. " Qualified candidate will have a minimum of 3-5 years experience in the design, analysis and development of defense or aerospace equipment. " Hands-on test and hardware experience is a plus. " Knowledge of fluid dynamics and heat transfer is required. Experience in the development of thermal systems is a strong plus. " Understanding of military specifications and environment desired. " Must have knowledge of drawing and drafting standards. " Must have the ability to meet cost, schedule, and technical performance requirements. " Strong organizational skills and ability to prioritize and work under time pressures required. " Long hours may sometimes be required. " Will be required to interact cooperatively with other engineers, multiple departments, customers, suppliers, and management. " Knowledge of ANSI Y14.5 standard is essential. " General machine shop experience is a plus. Should have hands-on experience in hydraulics, mechanical feed systems, linear controls, basic electronics, and servomechanisms.

Created: 2026-04-02