Test Technician

Job DescriptionShift: 1st Shift - 6:00 AM - 3:00 PM Schedule: 9/80 A Schedule (Every Other Friday Off)Weekend Work: As needed Clearance: Not Required U.S. Person Verification Required This role will support acceptance testing functions on both production and development/prototype products within the Advanced Product Center (APC) in McKinney, TX. The selected candidate will perform a wide variety of tasks and testing functions in support of a manufacturing/production environment on 1st shift. This position will work directly with engineering on production support and troubleshooting activities. Key Responsibilities Apply problem-solving skills to proactively identify alternate solutions to technical challenges. Fault-isolate issues and assist in resolving problems between the test environment (test stations, interface adapters, test cables, etc.) and devices under test. Observe, analyze, and report test data. Select and set up appropriate test equipment based on specifications. Interpret test data (plots, graphs, tabulated parameters) to determine pass/fail conditions and escalate when further analysis is required. Utilize hand tools, torque tools, analyzers, and power tools. Support production and troubleshooting efforts in a manufacturing environmentRequired Qualifications AA/AS degree (or other 2-year post high school training) OR minimum of 4 years of relevant experience. Experience using Microsoft Excel, drive share mapping, and basic computer programs. Experience performing product testing using procedures, manuals, schematics, engineering drawings, verbal instructions, and related documentation with limited supervision. U.S. Person verification required. Preferred Qualifications Minimum of 2 years of testing experience (STEM education may substitute for experience). Experience using oscilloscopes, pulse generators, programmable network analyzers, signal generators, multimeters, and other test equipment. Experience in manufacturing, assembly, aviation, or naval environments with hands-on technical experience in repair, installation, and inspection. Experience working with VM, CMES, SAP, or other manufacturing automation databases/tools. Physical Demands Ability to stand or sit for extended periods of time. Frequent use of hands for handling tools, components, and test equipment. Ability to lift and move items up to 25 pounds. Good manual dexterity and hand-eye coordination. Ability to visually inspect components and test results, including reading detailed documentation and test data. May require bending, reaching, and working in a production/manufacturing environment

Created: 2026-04-02