Manufacturing Technician I - Harness - 2nd Shift - ...

ATTENTION MILITARY AFFILIATED JOB SEEKERS, - Our organization works with partner companies to source qualified talent for their open roles. The following position is available to, Veterans, Transitioning Military, National Guard and Reserve Members, Military Spouses, Wounded Warriors, and their Caregivers. If you have the required skill set, education requirements, and experience, please click the submit button and follow the next steps. Unless specifically stated otherwise, this role is 'On-Site' at the location detailed in the job post.Eatonâs ES AMER ARS PDCAD division is currently seeking a Manufacturing Technician I - Harness - 2nd Shift.Shift hours: Monday - Thursday - 3:30pm-2:00am. Overtime may exceed these hours, and can be mandatory at times., The hourly rate for this position is $16.00 per hour, plus a $1/ hour increase for 2nd shift.Please note the salary information shown above is a general guideline only. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations., What youâll do:The Manufacturing Technician II - 2nd Shift will assemble, fit and mount sub-assemblies, components, and standard and near standard fixed assemblies in Motor Control Centers, Enclosed Control and related assemblies and this function you will:A. Work from oral or written instructions from supervision and/or prints, inspection reports, manufacturing information sheets, and standard or near standard wiring diagrams.B. Utilize mfg. information sheets, determine necessary parts, write requisitions, ,obtain materials from stock areas.C. Read shop orders and drawings to determine assembly procedures such as component types and configuration, mounting locations and clearances required.D. Assemble and fit parts and components to form sub-assemblies, or completed assemblies.E. Assemble and wire control devices, cutting wires to length.F. Make adjustments to insure correct alignment and clearances.G. Install units, pan assemblies and cover up steel, meters, kirk keys, pull boxes, reactors, relays, fuses, MTB assemblies, panel boards, space heaters, transformers, etc. by mounting / bolting into place. , Assemble and install bus work such as lug adapters, cross over bus, splices, etc.H. Make pre-bent cable unit, MTB and control panel harnesses using pre-cable boards, control panels and hand crimp lugs if necessary. , , I. Modify standard assemblies or doors as received. , May alter hole cutouts, etc. using hand or power tools.J. Make wiring changes as required. , , K. Use floor operated overhead and jib cranes. , Move units, harnesses, device panels, etc. from one area to another.L. Determine the quality of work reporting problems to area supervisor or Quality Control personnel. , Maintain piece count and associated records where applicable.M. Mark wires, devices or terminals as required. , Identify harness and/or panels with job and unit number. , Apply component ID labels such as âœBrady Markers❠or âœDymo❠labels if required. , Identify work and maintain records.N. Wear all safety equipment and observe all hygiene requirements as specified and directed.through the assembly / manufacturing process.

Created: 2026-01-28